A Look at an Original 1840s Corded Petticoat

1840s Woven Corded Petticoat front sm
1840s Corded Petticoat with cording woven in, front view

Many years ago I started researching corded petticoats. It all began because I wanted to make an 1830s dress and needed the proper silhouette underneath. There wasn’t much information out there. But I picked up bits and pieces and started to put together what they really were and how they were made.

Then I started collecting… I own a few originals, each with their own methods of construction but still similar. The particular petticoat I’m showing you here awed me. I’d heard of cords being actually woven into fabric but had never seen them…. until I bought this one on eBay. Can you say Jaw-Dropping Fantastic?!

1840s Woven Corded Petticoat back sm
1840s corded petticoat with woven cords, back view

c.1840s Corded Petticoat Vitals

  • Fabric: linen with cotton cord that has been starched
  • Length: 39 1/4″ including waistband
  • Width: 94″, made from 2 panels of roughly 47″ each
  • Waistband width: 1 1/2″
  • Width of cording section: 13 1/2″
  • Number of cord rows: 33
  • Hem: 3/8″ or 3/4″ from first cord to selvedge edge
  • Opening: 10″
  • Tuck: 7/8″ or 1 3/4″ total take up

 

The Woven Cords

Cording section sm
Cording section of petticoat

The 13 1/2″ section of cording is made from rows of cotton cording woven in the fabric with the selvedge turned up to create the small hem. A large tuck above it was probably there to shorten the petticoat as they used the entire width of the textile.

It was not uncommon for women to purchase lengths of pre-corded fabric and simply sew in a seam to create the undergarment. This petticoat was made by *somewhat* staggering the rows of cord to reduce bulk within the seam.

Seam outside sm
Petticoat seam from right side
Cords at Seam sm
Looking at the corded seam upclose

The seam allowance here is about 1/4″. It is made with a tiny running stitch. The cords were not trimmed before seaming and the edges are left loose (no whipstitching to finish).

Seam inside sm
Seam as it looks on the inside
Seam close sm
Extreme close up of petticoat seam with cords

 

Cords up close sm
Another close up view of the cord and 3/8″ wide hem (inside view). You can see the threads running over the cord that were done during the weaving process.

The filler really does appear like a braided cord, not loose shreds of other fiber.

Hem sm
Extreme close up of the hem on inside where you can just make out the slip stitch threads.

 

The waistband is wide at 1 1/2″ and unsupported by any type of underlining. The width helps keep it flat against the tight corset. The skirt is set onto the waistband in large knife pleats.

Wide Waistband sm
The wide petticoat waistband with the skirt pleated into it to fit.

What I find fascinating is that there are no closures on the waistband. The ends around the opening have been repaired with pieces of cotton but no sign of hook & eyes or even tapes sewn to the edges to tie closed.

Waistband patching sm
Waistband showing repairs at the opening edges

The opening itself is cut straight into the fabric down 10″ from the waistband seam. The edges were rolled inside and stitched down.

Opening sm
Petticoat opening

Another unusual item about this petticoat is the shoulder straps. I’ve seen them on Regency dresses, both skirts and petticoats, but not on a corded petticoat this late into the century. They are quite long making the waistband sit pretty much at the waist.

Shoulder straps sm
Shoulder straps attached to the corded petticoat

Now that I look at the photos again, I have to admit I may have the petticoat on backward on the dressform. From the photo above the pleats seem to be wide then taper off as they near the opening. That opening may actually be in the center front. Skirts of this era were commonly pleated with the pleats facing forward. This would make sense to have more fabric in the back to fall over a small pad worn right beneath the corded petticoat. hmm….

023 Woven Cords
Woven cords of the petticoat

What do you think about this corded petticoat? Have you woven cords into fabric before or seen it done?

12 thoughts on “A Look at an Original 1840s Corded Petticoat

  1. Lucy says:

    I think that petticoat is actually not 1840s at all! but rather 1820s in fact. The way the straps suspend the petticoat above the natural waistline, along with the fact that the cording only appears to have been applied in the bottom of the petticoat rather than consistently all the way up gives it a conical shape rather than a bell shape. This petticoat reflects the skirt shapes of the 1820s rather than the 1840s.

    • Jennifer Rosbrugh says:

      I would actually agree with you. When I first acquired this corded petticoat I dated it to the 1840s as that was my area of research, and it was too narrow for 1830s. But the straps, as you said, date it earlier as we can see a number of existing undergarments with shoulder straps like this from the 18-Teens through 1820s. The straps, the narrow width, and only lower half being corded are all great points to put it in the 1820s. Thanks for your comment!

  2. Sam B says:

    I’m wondering if the “woven in” look could be replicated by removing several consecutive threads and replacing them with the cording…and if it would actually be worth the hassle : P I might try it…once.

  3. Magdelina says:

    My mom Is going to teach me how to weave so that I can make this. What is the measurement in between the cords?

  4. Lorelei says:

    Thank you for the closer look. It allows me to distill my earlier thoughts, re: the weaving of the petticoat. Since the selvages are an intrical part of the hem, and therefor the waist, the cording must run the length of the fabric. Perviously I thought that the cording was actually warp threads, but I’ve come to the conclusion that in fact, the cords are laid in while the weaver is throwing the shuttle. My reason for this thought is that the reed would have had to be altered to fit the extra spacing of the cording, and reeds were too pricey to be willing to ruin one for such a project. So what it appears to me is….the linen singles were sett as a spaced warp; areas of close threads for the plain weave stripes followed by spaces where there were no warp threads, and repeat, for as many cords as you wish. As the weaving progressed, the number of cotton cords were allowed to be caught in the web, it looks like every other pick, then raised out of the way. Process repeated.
    Personally, it would have been much easier to place the cording in the weft, but then the petticoat would have needed more than one panel.

  5. Joy Flasher says:

    I’ve not seen any photos of corded petticoats with the cording ‘woven’ in. This is a first for me. What an awesome technique. Will have to try it some day.

  6. Ginger says:

    I love these pictures! I’ve known about these, but never seen such clear photos before.

    The weaver at Genesee Country Village and Museum made a run of corded petticoat fabric last spring. They just announced that she’s weaving enough for a few more petticoats, if anyone is interested! More info here, including links to pictures of a completed reproduction, and info on starching it.

    http://thesewingacademy.org/index.php?topic=8760.0

Leave a Reply to Joy Flasher Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.